Do not allow any stray wire strands to connect with a neighboring wires as this cause an electrical short between the wires. To avoid accidental shorts no bare wire should be left exposed outside of the Euroblock connector. Trim any loose wire strands or re-terminate the wire to address them.
3 + 4 This will send a stereo mix out over the output usually used for Center. 1 + 2 The most common setting for standard stereo audio outputs. These are typically used to output surround sound, but can be used to output up to three independent stereo audio mixes in vMix. Terminal screws should not be crimping down on the insulation as this will prevent a proper electrical connection with the bare wire. Many sound cards provide 3 or more stereo outputs from a single device. This article shows the most typical wiring schemes used with Biamp Audia and Nexia hardware.Īlways ensure that the Euroblock screw connectors are snugly tightened onto properly trimmed bare wire leads. Depending on the models, some Sound Blaster support playback priority if 2 or more audio sources are played simultaneously. With the many I/O card options available to the Biamp family and the multitude of wiring formats and schemes in the industry, it can be difficult to remember how to wire certain things for proper operation. In the Audio I/O Setup menu there are two tabs: one for input. I hope this is the correct forum for this question. The input sources and output destinations made available to each Track are determined by.
